Edelbrock Vortec EGR Adapter Kit
Catalog #2899
INSTALLATION INSTRUCTIONS
PLEASEstudy these instructions carefully before installing your EGR Adapter kit. If you have any questions or problems, contact our Technical Hotline
at: 1-800-416-8628 , 7am - 5pm, Monday-Friday, Pacific Standard Time or e-mail us at edelbrock@edelbrock.com.
DESCRIPTION: This adapter kit is intended for the customer who already has a set of headers in his truck that he wishes to re-use with his new Vortec
engine.
KIT CONTENTS
PARTS REQUIRED
Qty.
1
Description
Qty.
1
Description
Vortec EGR Supply Fitting (#24-9715)
GM #10220275 EGR Supply Tube
GM #12552329 Adapter Fitting
1
.75” O.D. x 1.25” Long, Bent Tube (#79-9643)
.75” O.D. x 6” Long, Bent Tube (#79-9574)
1
1
Edelbrock Kit #2899
GM EGR Supply Tube #10220275
INSTALLATION INSTRUCTIONS
GM Adapter Fitting #12552329
1. Attach GM EGR Supply Tube (#10220275) and GM Adapter Fitting (#12552329) to intake manifold (See Fig. 1). Do not tighten at this time!
2. Attach supplied EGR Supply Fitting to the GM Adapter Fitting (See Fig. 1). Do not tighten.
3. Using one of the Edelbrock bent tubes at a time, position the tubes agains the under side of the fitting and against the side of the header primary
tube. (Use the tube that allows the EGR-supply tube to be positioned in the vehicle so it has adequate clearance around other components). Bent
tubes can be trimmed as needed (See Fig. 1).
4. Once you have selected the tube that fits your application best, remove the Edelbrock
fitting from the EGR-supply tube and weld the fitting to the selected bent tube.
5. Re-install the fitting with the welded on tube and position the tube opening against the
header primary tube, mark the primary tube, remove the header and drill a 1/2” diameter
hole where you have marked.
6. For best fit, re-install the header into position, re-install the fitting onto the EGR-supplied
tube and tack weld.
7. Remove the header and complete the weld.
8. Re-install header with new gaskets and hardware. Tighten the GM adapter fitting into the
welded on tube and fitting, and tighten the fittings on both ends of EGR-supply tube.
Figure 1 - Installed Supply Tube
WARNING!!!
Exhaust gas contains carbon monoxide, a deadly invisible gas. Correct any leaks before driving!
Edelbrock Corporation • 2700 California Street • Torrance, CA 90503
Toll-Free Tech Line: 1-800-416-8628
Tech E-Mail: edelbrock@edelbrock.com
©2004 Edelbrock Corporation
Rev. 12/04
Catalog #2899
Brochure #63-0234
|
Eagle Electronics Fish Finder Fish ID II User Manual
Earthquake Sound Speaker SuperNova MKV User Manual
Ei Electronics Smoke Alarm Ei100L User Manual
Ei Electronics Smoke Alarm Ei 407 User Manual
ELANsat Tech Speaker System Wireless Digital Audio User Manual
Everpure Water System EV9100 66 User Manual
Extron electronic TV Receiver AVT 100N User Manual
Garmin GPS Receiver StreetPilot i2 User Manual
GE Convection Oven 169068 User Manual
Gefen Computer Drive 144NP User Manual